Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 30-120 minutes

Alarm 300865

Siemens 300865 - Axis drive measurement of DC link voltage not possible

If the fixed voltage MD 1161: $MD_FIXED_LINK_VOLTAGE(DC link fixed voltage) = 0, no DC link measurement is possible because the hardware version is wrong Control reaction: Interface signals are set. Alarm display.

Siemens SINUMERIKServo/AxisIntermediate30-120 minutes

300865

Siemens 300865 - Axis drive measurement of DC link voltage not possible

Axis drive measurement of DC link voltage not possible

If the fixed voltage MD 1161: $MD_FIXED_LINK_VOLTAGE(DC link fixed voltage) = 0, no DC link measurement is possible because the hardware version is wrong Control reaction: Interface signals are set. Alarm display.

Safety

  • Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.

Common Causes

  • If the fixed voltage MD 1161: $MD_FIXED_LINK_VOLTAGE(DC link fixed voltage) = 0, no DC link measurement is possible because the hardware version is wrong

Troubleshooting Steps

  1. 1Please inform the authorized personnel/service department.
  2. 2Enter a value greater than zero in the machine data MD 1161: $MD_FIXED_LINK_VOLTAGE (DC link fixed voltage), or order a new hardware version of the control module.
  3. 3Alarm display showing cause of alarm disappears. No further operator action necessary

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.