What causes KUKA Robot alarm KRC0008?

Backup battery depletion preventing the real-time clock circuit from maintaining time during power loss. Corrupted CMOS or system clock memory due to power surges, ESD, or hardware failure. Defective clock crystal oscillator or clock circuit component on the main control board. Firmware corruption or incomplete system boot sequence that failed to initialize clock settings. Previous hardware failure event that damaged the clock circuit without being fully recovered during reset.

How do I fix KUKA Robot alarm KRC0008?

1. Perform a full power cycle by disconnecting main power supply for 60 seconds, then power on the controller to attempt clock recovery 2. Access System Settings on the KUKA smartPAD and manually set the system date and time to correct values using the configuration menu 3. Verify that the backup battery has adequate voltage using the System Information display, as described in KRC0004 battery troubleshooting 4. Check the system log for any TIME_HW_FAILURE messages to confirm clock failure type and review associated error history 5. If the clock does not synchronize or resets on reboot, the real-time clock circuit may be defective and requires replacement of the main processor board 6. Contact KUKA customer support for advanced diagnostics or board replacement if manual clock setting does not persist after power cycling

KUKA Robot codes

axismd.ai

KUKA Robot Controller

System · Intermediate

Alarm KRC0008

KUKA Robot KRC0008 - System Time Invalid

The system real-time clock in the KRC4 has become invalid or corrupted, preventing accurate timekeeping required for motion synchronization and logging functions. This condition is triggered after a hardware time failure and requires manual intervention to restore the system clock before normal robot operation can resume.

KUKA RobotSystemIntermediate

KRC0008

KUKA Robot KRC0008 - System Time Invalid

System Time Invalid

Common Causes

Backup battery depletion preventing the real-time clock circuit from maintaining time during power loss
Corrupted CMOS or system clock memory due to power surges, ESD, or hardware failure
Defective clock crystal oscillator or clock circuit component on the main control board
Firmware corruption or incomplete system boot sequence that failed to initialize clock settings
Previous hardware failure event that damaged the clock circuit without being fully recovered during reset

Troubleshooting Steps

1Perform a full power cycle by disconnecting main power supply for 60 seconds, then power on the controller to attempt clock recovery
2Access System Settings on the KUKA smartPAD and manually set the system date and time to correct values using the configuration menu
3Verify that the backup battery has adequate voltage using the System Information display, as described in KRC0004 battery troubleshooting
4Check the system log for any TIME_HW_FAILURE messages to confirm clock failure type and review associated error history
5If the clock does not synchronize or resets on reboot, the real-time clock circuit may be defective and requires replacement of the main processor board
6Contact KUKA customer support for advanced diagnostics or board replacement if manual clock setting does not persist after power cycling

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.