axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 10805 - Block repositioning after switch of geometry axes or transformation
In the asynchronous subroutine the assignment of geometry axes to channel axes was changed or the active transformation modified Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
10805
Siemens 10805 - Block repositioning after switch of geometry axes or transformation
Block repositioning after switch of geometry axes or transformation
In the asynchronous subroutine the assignment of geometry axes to channel axes was changed or the active transformation modified Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- In the asynchronous subroutine the assignment of geometry axes to channel axes was changed or the active transformation modified
Troubleshooting Steps
- 1Modify part program.
- 2Clear alarm with the RESET key. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.