axismd.ai
Heidenhain Controller
System · Intermediate · 30-120 minutes
HEIDENHAIN 230-0011 - This software version has not been enabled
This TNC7/TNC 640 error indicates an issue with 230-0011. Wrong software installed.
230-0011
HEIDENHAIN 230-0011 - This software version has not been enabled
This software version has not been enabled
This TNC7/TNC 640 error indicates an issue with 230-0011. Wrong software installed.
Safety
- Do not attempt to run the axis with a known encoder fault — position loss can cause a crash
Common Causes
- Wrong software installed
Troubleshooting Steps
- 1Note the full error text and the NC software number of the control
- 2Contact your machine builder or HEIDENHAIN service
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.