Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Overtravel/Limit · Intermediate · 30-60 minutes

Alarm 26076

Siemens 26076 - Axis not available for NC program, firmly assigned PLC axis

The axis is a firmly assigned PLC axis. The axis is therefore not available for the NC program Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Siemens SINUMERIKOvertravel/LimitIntermediate30-60 minutes

26076

Siemens 26076 - Axis not available for NC program, firmly assigned PLC axis

Axis not available for NC program, firmly assigned PLC axis

The axis is a firmly assigned PLC axis. The axis is therefore not available for the NC program Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The axis is a firmly assigned PLC axis.
  • The axis is therefore not available for the NC program

Troubleshooting Steps

  1. 1Do not define axis as a firmly assigned PLC axis.
  2. 2Change of MD30460 $MA_BASE_FUNCTION_MASK bit5.
  3. 3Clear alarm with the RESET key. Restart part program Continuation: Alarms

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.