axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 26075 - Axis not available for the NC program, as exclusively controlled by
The axis is exclusively controlled by the PLC. Therefore, the axis is not available for the NC program Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
26075
Siemens 26075 - Axis not available for the NC program, as exclusively controlled by
Axis not available for the NC program, as exclusively controlled by
The axis is exclusively controlled by the PLC. Therefore, the axis is not available for the NC program Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The axis is exclusively controlled by the PLC.
- Therefore, the axis is not available for the NC program
Troubleshooting Steps
- 1Have the axis not exclusively controlled by the PLC, but only temporarily.
- 2Change MD30460 $MA_BASE_FUNCTION_MASK, bit 4.
- 3Clear alarm with the RESET key. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.