Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 26082

Siemens 26082 - Channel ESR for PLC-controlled axis has been triggered

An axial ESR has been triggered for an individual axis (PLC-controlled axis): The display can be suppressed by machine date MD 11410: SUPPRESS_ALARM_MASK bit28 = 1 Control reaction: Alarm display.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

26082

Siemens 26082 - Channel ESR for PLC-controlled axis has been triggered

Channel ESR for PLC-controlled axis has been triggered

An axial ESR has been triggered for an individual axis (PLC-controlled axis): The display can be suppressed by machine date MD 11410: SUPPRESS_ALARM_MASK bit28 = 1 Control reaction: Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • An axial ESR has been triggered for an individual axis (PLC-controlled axis): The display can be suppressed by machine date MD 11410: SUPPRESS_ALARM_MASK bit28 = 1

Troubleshooting Steps

  1. 1The individual axis is in axial stop after the ESR movement.
  2. 2If an axial reset is performed for the individual axis, the alarm will be deleted and the individual axis can be traversed again.
  3. 3Alarm display showing cause of alarm disappears. No further operator action necessary. The individual axis is in axial stop after the ESR movement. If an axial reset is performed for the individual axis, the alarm will be deleted and the individual axis can be traversed again

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.