Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 10652

Siemens 10652 - Axis gantry warning threshold exceeded

The gantry following axis has exceeded the warning limit specified in MD37110 $MA_GANTRY_POS_TOL_WARNING Control reaction: Alarm display.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

10652

Siemens 10652 - Axis gantry warning threshold exceeded

Axis gantry warning threshold exceeded

The gantry following axis has exceeded the warning limit specified in MD37110 $MA_GANTRY_POS_TOL_WARNING Control reaction: Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The gantry following axis has exceeded the warning limit specified in MD37110 $MA_GANTRY_POS_TOL_WARNING

Troubleshooting Steps

  1. 1Please inform the authorized personnel/service department.
  2. 21.
  3. 3Check axis (uneven mechanical movement?) 2.
  4. 4MD not set correctly (MD37110 $MA_GANTRY_POS_TOL_WARNING).
  5. 5Changes to this MD take effect after a RESET.
  6. 6Alarm display showing cause of alarm disappears. No further operator action necessary

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.