Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 10700

Siemens 10700 - Block NCK protection zone violated during automatic or MDI

The workpiece-related NCK protection zone has been violated. Note that another tool-related protection zone is still active. The workpiece-related protected area can be traversed after a new NC Start Control reaction: Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm. Alarms.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

10700

Siemens 10700 - Block NCK protection zone violated during automatic or MDI

Block NCK protection zone violated during automatic or MDI

The workpiece-related NCK protection zone has been violated. Note that another tool-related protection zone is still active. The workpiece-related protected area can be traversed after a new NC Start Control reaction: Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm. Alarms.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The workpiece-related NCK protection zone has been violated.
  • Note that another tool-related protection zone is still active.
  • The workpiece-related protected area can be traversed after a new NC Start

Troubleshooting Steps

  1. 1Protection zone can be traversed after a new NC Start.
  2. 2Clear alarm with NC START or RESET key and continue the program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.