What causes Siemens SINUMERIK alarm 101114?

Required machine data or parameter not configured for the requested function. Option bit not set in SINUMERIK to enable the required functionality. Program references a function or axis that has not been configured. Machine commissioning incomplete — required setup step was not performed. Configuration data cleared or lost due to a parameter reset or hardware change.

How do I fix Siemens SINUMERIK alarm 101114?

1. Read the full alarm message to identify what is missing (axis name, parameter number, function name). 2. Consult the SINUMERIK alarm manual for alarm 101114 for the specific configuration requirement. 3. Check the relevant machine data group and set the required parameter. 4. If a specific option is required, verify it is licensed and enabled in the SINUMERIK option settings. 5. Power cycle after making configuration changes to apply the new settings.

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 101114

Siemens 840D 101114 - No MSD configured !

Alarm 101114 indicates that the Master Safety Data (MSD) configuration is incomplete or missing in the 840D system. This occurs when the safety-integrated drives have not been properly configured during commissioning, or when MSD machine data has been corrupted or deleted, preventing the system from accessing required safety parameters.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

101114

Siemens 840D 101114 - No MSD configured !

No MSD configured !

Root Cause Summary

Alarm 101114 indicates that the Master Safety Data (MSD) configuration is incomplete or missing in the 840D system. This occurs when the safety-integrated drives have not been properly configured during commissioning, or when MSD machine data has been corrupted or deleted, preventing the system from accessing required safety parameters.

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Causes and Fixes

1
Access SINUMERIK Operate in commissioning mode and navigate to 'Safety Integrated' commissioning area to verify current MSD status.
2
Check if Safety Integrated is required for your application. If not needed, disable Safety Integrated features in machine data MD9009 $MN_SAFE_ENABLE = 0.
Disabling safety features removes all safety-integrated functionality. Ensure this meets your safety requirements.
3
If Safety Integrated is required, run the complete Safety Integrated commissioning wizard through HMI under 'Commissioning > Safety Integrated > Create new project'.
4
After completing safety commissioning, perform a complete power cycle (power OFF/ON) to activate the MSD configuration and verify alarm clears.
Ensure machine is in safe state before power cycling.

Service Recommended confidence

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.