KUKA Robot codes
AxisMD

axismd.ai

KUKA Robot Controller

System · Basic

Alarm KRC0265

KUKA Robot KRC0265 - INCOMPLETE INSTRUCTION

This alarm indicates that the Single Board Computer (SBC) interface has failed to initialize properly during the robot controller startup sequence. The SBC is a critical component responsible for handling motion control and real-time processing, and without proper initialization, the controller cannot establish communication with the robot's mechanical systems.

KUKA RobotSystemBasic

KRC0265

KUKA Robot KRC0265 - INCOMPLETE INSTRUCTION

INCOMPLETE INSTRUCTION

This alarm indicates that the Single Board Computer (SBC) interface has failed to initialize properly during the robot controller startup sequence. The SBC is a critical component responsible for handling motion control and real-time processing, and without proper initialization, the controller cannot establish communication with the robot's mechanical systems.

Common Causes

  • Power supply failure or insufficient voltage to the SBC module
  • Corrupted firmware or operating system on the SBC
  • Loose or damaged communication cable between the main KRC controller and SBC
  • Failed SBC hardware component or module requiring replacement
  • BIOS/EEPROM settings corrupted or reset to invalid configuration

Troubleshooting Steps

  1. 1Power cycle the entire robot controller by removing main power for 30 seconds, then restart and observe if the alarm clears
  2. 2Verify all physical connections between the KRC main controller and SBC module are firmly seated and undamaged
  3. 3Check the system power supply voltage output is within specification (typically 24VDC ±10%) using a multimeter
  4. 4Access the KRC startup diagnostics menu to run SBC self-test procedures and document any error codes reported
  5. 5If available, attempt a firmware re-flash of the SBC using official KUKA software and verified firmware image files
  6. 6Contact KUKA service or replace the SBC module if hardware failure is confirmed and all software troubleshooting steps fail

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.