000

Record which parameter was changed and the new value for verification after reboot.

Set parameter write enable back to 0 (PWE=0) using the keep relay or parameter setting page.

Perform a complete power cycle - turn the control OFF, wait 10 seconds, then turn back ON.

Ensure machine is in a safe state and all axes are secure before power cycling.

After reboot, verify the parameter change took effect by checking the parameter value and testing affected functionality.

Review recent parameter changes through the parameter history or diagnostic screens to identify what was modified.

If the change was unintentional, restore the original parameter value from backup or documented baseline before power cycling.

Ensure you have correct original values - incorrect parameters can cause machine malfunction.

Disable parameter write (PWE=0) to prevent further accidental changes.

Power cycle the machine only after confirming all parameter values are correct.

Document all changes made for maintenance records.

Verify all intended parameter changes are complete by cross-referencing against setup documentation or parameter list.

Create a backup of all current parameters using the backup function (CF card, USB, or network) before power cycling.

Always maintain parameter backups before major changes.

Set PWE=0, then perform complete power cycle to activate all changes simultaneously.

After reboot, systematically verify all modified parameters and test all affected machine functions before releasing to production.

Run dry cycles and test emergency stops after parameter changes.