Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 810015

Siemens 840D 810015 - Module diagnositcs event, error analysis via STEP 7 required

Siemens SINAMICS drive alarm 810015: Module diagnositcs event, error analysis via STEP 7 required. This alarm indicates a fault condition in the SINAMICS servo drive system. Refer to the Siemens SINAMICS fault list documentation for the complete remedy.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

810015

Siemens 840D 810015 - Module diagnositcs event, error analysis via STEP 7 required

Module diagnositcs event, error analysis via STEP 7 required

Siemens SINAMICS drive alarm 810015: Module diagnositcs event, error analysis via STEP 7 required. This alarm indicates a fault condition in the SINAMICS servo drive system. Refer to the Siemens SINAMICS fault list documentation for the complete remedy.

Safety

  • Refer to Siemens documentation
  • Ensure qualified technician performs repairs

Common Causes

  • SINAMICS drive hardware fault requiring investigation
  • Drive parameter configuration error
  • Axis motor or feedback system fault triggering drive protection
  • Communication fault on the drive bus
  • Power supply issue affecting the drive module

Troubleshooting Steps

  1. 1Check the SINAMICS drive for active fault codes in the diagnostics screen.
  2. 2Power cycle the machine to clear transient faults.
  3. 3Review SINAMICS parameters for the affected drive axis.
  4. 4Check the SINUMERIK axis diagnostics for related NC alarms.
  5. 5Consult the Siemens SINAMICS alarm manual for alarm 810015 complete remedy.

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.