Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 30-60 minutes

Alarm 6433

Siemens 6433 - Block not available with tool management

The symbol variable specified in is not available with active tool management. The function GELSELT should be used with $P_TOOLP Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Siemens SINUMERIKServo/AxisIntermediate30-60 minutes

6433

Siemens 6433 - Block not available with tool management

Block not available with tool management

The symbol variable specified in is not available with active tool management. The function GELSELT should be used with $P_TOOLP Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The symbol variable specified in %3 is not available with active tool management.
  • The function GELSELT should be used with $P_TOOLP

Troubleshooting Steps

  1. 1Modify program.
  2. 2If $P_TOOLP has been programmed, the GETSELT function should be used instead.
  3. 3Clear alarm with the RESET key. Restart part program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.