axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 20-40 minutes
Siemens 61113 - Block : Parameter for corner radius too large
The parameter for the corner radius _CRAD has been specified too large Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
61113
Siemens 61113 - Block : Parameter for corner radius too large
Block: Parameter for corner radius too large
The parameter for the corner radius _CRAD has been specified too large Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The parameter for the corner radius _CRAD has been specified too large
Troubleshooting Steps
- 1Reduce corner radius
- 2Clear alarm with the RESET key. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.