Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 4225

Siemens 4225 - Axis declaration as rotary axis missing

The modulo functionality requires a rotary axis (positions in [deg]) Control reaction: Mode group not ready. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

4225

Siemens 4225 - Axis declaration as rotary axis missing

Axis declaration as rotary axis missing

The modulo functionality requires a rotary axis (positions in [deg]) Control reaction: Mode group not ready. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The modulo functionality requires a rotary axis (positions in [deg])

Troubleshooting Steps

  1. 1Please inform the authorized personnel/service department.
  2. 2Set MD30300 $MA_IS_ROT_AX.
  3. 3Switch control OFF - ON

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.