axismd.ai
Siemens SINUMERIK Controller
Spindle · Intermediate · 30-60 minutes
Siemens 22321 - Axis PRESET not allowed during traverse motion
A preset command was sent from the HMI or PLC while an axis was traveling in JOG mode Control reaction: Interface signals are set. Alarm display.
22321
Siemens 22321 - Axis PRESET not allowed during traverse motion
Axis PRESET not allowed during traverse motion
A preset command was sent from the HMI or PLC while an axis was traveling in JOG mode Control reaction: Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- A preset command was sent from the HMI or PLC while an axis was traveling in JOG mode
Troubleshooting Steps
- 1Wait until the axis is stationary.
- 2Clear alarm with the Delete key or NC START
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.