axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 10946 - Block curve table : no contour defined
No movement for the leading axis was programmed between CTABDEF and CTABEND. A curve table is not permitted without a contour Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
10946
Siemens 10946 - Block curve table : no contour defined
Block curve table: no contour defined
No movement for the leading axis was programmed between CTABDEF and CTABEND. A curve table is not permitted without a contour Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- No movement for the leading axis was programmed between CTABDEF and CTABEND.
- A curve table is not permitted without a contour
Troubleshooting Steps
- 1Correct the part program and start it again.
- 2Clear alarm with the RESET key. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.