axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 10948 - Block curve table : position jump at end of period
A periodic curve table was defined in which the position of the following axis at the end of the table was different to the position at the start of the table Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
10948
Siemens 10948 - Block curve table : position jump at end of period
Block curve table: position jump at end of period
A periodic curve table was defined in which the position of the following axis at the end of the table was different to the position at the start of the table Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- A periodic curve table was defined in which the position of the following axis at the end of the table was different to the position at the start of the table
Troubleshooting Steps
- 1Correct the part program and start it again.
- 2Clear alarm with the RESET key. Restart part program Continuation: Alarms
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.