10208

Verify all axes are at the correct positions by checking the actual position display against the desired block search target position.

Confirm tool offsets, work offsets, and modal G-codes are correctly set for the target block by reviewing the active status displays.

If position and machine state are correct, press NC START to resume program execution from the searched block.

Ensure workpiece, fixtures, and tool clearances are safe before starting. Reduce feedrate override to 25-50% for first move verification.

If adjustments are needed, use JOG mode to reposition axes or OVERSTORE function to modify modal values before pressing NC START.

Check the program block number displayed matches your intended restart point in the NC program.

Verify tool number in spindle matches the T-code active at the searched block. Change tool manually if mismatch exists.

Confirm coolant, spindle speed, and feed rate values are appropriate for resuming at this program location.

Perform a dry run in single block mode if uncertain about the restart conditions, then switch to automatic mode with NC START.

Use machine protect key or feedrate override as safety measure during first moves after block search.

Document any manual operations performed during the interruption (tool changes, workpiece adjustments, fixture modifications).

If workpiece was moved or re-clamped, re-establish work coordinate system using probing or edge finding before continuing program.

Do not proceed if workpiece datum cannot be verified to match original setup.

Use REPOS function if axes were moved manually during interruption to synchronize actual position with programmed path.

After all corrections are complete and verified, acknowledge the message and press NC START to resume production.