230-032C

Verify System Status

Check MOD function -> System Info -> Hardware to confirm all supply modules are properly detected and operational.

This is typically an informational alarm that clears automatically after successful registration.

Review Configuration

Navigate to MOD -> Machine Parameters -> CfgSupplyModule to verify the detected module appears with correct name and parameters.

Document the module serial number and configuration for future reference.

Clear Alarm

Press CE key to acknowledge the informational alarm after verifying proper module registration.

Only clear after confirming the supply module is functioning correctly.

Verify Physical Installation

Check that the new supply module is properly seated in the cabinet with all connections secure and LED indicators showing normal operation.

Ensure main power is off before checking physical connections.

Check Module Parameters

Access MOD -> Machine Parameters -> CfgSupplyModule and verify the new module parameters match the hardware specifications and axis requirements.

Compare with previous module settings if replacing a failed unit.

Perform Axis Test

Execute manual axis movement in MDI mode to verify the supply module is providing adequate power and the axis responds correctly.

Start with low feed rates and gradually increase to verify stable operation.

Update Documentation

Record the new module information in machine documentation and update any relevant machine parameter backups.

Save machine parameters to external storage after successful configuration.

Verify Parameter Status

Check MOD -> Machine Parameters -> General to confirm if parameters were recently reset or restored from backup.

Look for parameter modification timestamps to identify recent changes.

Validate Supply Configuration

Navigate through CfgSupplyModule entries to ensure all supply modules are correctly registered with proper axis assignments.

Cross-reference with machine electrical drawings to verify correct module-to-axis mapping.

Test All Axes

Perform reference point approach for all axes to verify supply modules are providing correct power levels and axis operation is normal.

Ensure work area is clear before initiating reference point sequence.

Check Network Status

Access MOD -> System Info -> Network to verify stable communication between TNC and all drive components including supply modules.

Look for any communication error counters or timeout indicators.

Verify Module Communication

Navigate to MOD -> Diagnosis -> Drive Diagnosis to check individual supply module communication status and error logs.

Check for any recurring communication errors that might indicate intermittent connection issues.

Monitor System Stability

Run continuous axis movements while monitoring for any communication alarms or supply module disconnections.

Stop immediately if any drive alarms occur during testing.

Check Cable Connections

Inspect EnDat/communication cables between TNC and supply modules for proper seating and cable integrity.

Power down system before checking cable connections.