What causes Siemens SINUMERIK alarm 61353?

Logfile directory path specified in _PROTNAME[1] parameter does not exist on the system. Incorrect or incomplete directory path syntax in _PROTNAME[1] parameter. Network drive or shared folder specified in path is disconnected or unavailable. Insufficient user permissions to access the specified directory. CYCLE106 invoked before logfile directory initialization or configuration.

How do I fix Siemens SINUMERIK alarm 61353?

1. Verify the directory path specified in _PROTNAME[1] parameter exists on the control system or connected storage 2. Check parameter _PROTNAME[1] syntax for correct path formatting (forward slashes, drive letters, or network paths as appropriate for your system) 3. If using network paths, confirm the network drive is mounted and accessible from the CNC control 4. Validate file system permissions allow the CNC control user account to write to the specified directory 5. Create the missing directory manually if it does not exist, or correct _PROTNAME[1] to point to an existing valid path, then retry CYCLE106

Siemens SINUMERIK codes

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 20-40 minutes

Alarm 61353

Siemens 840D 61353 - Channel Block: Path for logfile not found

The alarm is triggerd by the following cycles: CYCLE106. The specified directory does not exist or the specified path is incorrect. Remedy: Check parameter _PROTNAME[1].

Siemens SINUMERIKServo/AxisIntermediate20-40 minutes

61353

Siemens 840D 61353 - Channel Block: Path for logfile not found

Channel Block: Path for logfile not found

The alarm is triggerd by the following cycles: CYCLE106. The specified directory does not exist or the specified path is incorrect. Remedy: Check parameter _PROTNAME[1].

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Common Causes

Logfile directory path specified in _PROTNAME[1] parameter does not exist on the system
Incorrect or incomplete directory path syntax in _PROTNAME[1] parameter
Network drive or shared folder specified in path is disconnected or unavailable
Insufficient user permissions to access the specified directory
CYCLE106 invoked before logfile directory initialization or configuration

Troubleshooting Steps

1Verify the directory path specified in _PROTNAME[1] parameter exists on the control system or connected storage
2Check parameter _PROTNAME[1] syntax for correct path formatting (forward slashes, drive letters, or network paths as appropriate for your system)
3If using network paths, confirm the network drive is mounted and accessible from the CNC control
4Validate file system permissions allow the CNC control user account to write to the specified directory
5Create the missing directory manually if it does not exist, or correct _PROTNAME[1] to point to an existing valid path, then retry CYCLE106

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.