What causes Siemens SINUMERIK alarm 61332?

Tool tip positioned below the measuring probe surface during tool measurement cycle initialization. Incorrect tool offset or tool length compensation values causing tool to approach from below probe. Measuring probe (ring gauge, cube, or similar reference) positioned too high relative to tool parking position. Tool holder or spindle orientation misaligned, affecting tool approach geometry. Previous tool measurement cycle incomplete or aborted, leaving tool in incorrect position.

How do I fix Siemens SINUMERIK alarm 61332?

1. Manually position the tool above the measuring probe surface using MDI or manual jog, then verify clearance visually 2. Review and correct tool offset table values (tool length and radius compensation) in the part program or offset management screen 3. Check measuring probe mounting height and re-establish probe reference position using calibration routine if needed 4. Inspect spindle orientation and tool holder seating; ensure tool is fully seated and spindle is at correct angle for measurement cycle 5. Clear the alarm, restart the tool measurement cycle (CYCLE971, CYCLE972, CYCLE982, E_MT_CAL, E_MT_LEN, or E_MT_RAD) and observe tool approach path

Siemens SINUMERIK codes

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 20-45 minutes

Alarm 61332

Siemens 840D 61332 - Channel Block: Modify tool tip position

The tool tip is below the measuring probe surface (e.g. for a ring gauge or cube). Alarm is triggered: CYCLE971, CYLCE972, CYCLE982, E_MT_CAL, E_MT_LEN, E_MT_RAD. Remedy: Place the tool above the measuring probe surface.

Siemens SINUMERIKServo/AxisIntermediate20-45 minutes

61332

Siemens 840D 61332 - Channel Block: Modify tool tip position

Channel Block: Modify tool tip position

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Common Causes

Tool tip positioned below the measuring probe surface during tool measurement cycle initialization
Incorrect tool offset or tool length compensation values causing tool to approach from below probe
Measuring probe (ring gauge, cube, or similar reference) positioned too high relative to tool parking position
Tool holder or spindle orientation misaligned, affecting tool approach geometry
Previous tool measurement cycle incomplete or aborted, leaving tool in incorrect position

Troubleshooting Steps

1Manually position the tool above the measuring probe surface using MDI or manual jog, then verify clearance visually
2Review and correct tool offset table values (tool length and radius compensation) in the part program or offset management screen
3Check measuring probe mounting height and re-establish probe reference position using calibration routine if needed
4Inspect spindle orientation and tool holder seating; ensure tool is fully seated and spindle is at correct angle for measurement cycle
5Clear the alarm, restart the tool measurement cycle (CYCLE971, CYCLE972, CYCLE982, E_MT_CAL, E_MT_LEN, or E_MT_RAD) and observe tool approach path

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.