axismd.ai
Siemens SINUMERIK Controller
Servo/Axis · Intermediate · 20-40 minutes
Siemens 840D 61339 - Channel Block:Correction factor for rapid traverse speed = 0
Alarm can be triggered by following measuring cycles: all measuring cycles. Remedy: Check parameter _SPEED[0] in GUD6.
61339
Siemens 840D 61339 - Channel Block:Correction factor for rapid traverse speed = 0
Channel Block:Correction factor for rapid traverse speed = 0
Alarm can be triggered by following measuring cycles: all measuring cycles. Remedy: Check parameter _SPEED[0] in GUD6.
Safety
- Refer to Siemens documentation
- Ensure qualified technician performs repairs
Common Causes
- Parameter _SPEED[0] in GUD6 is set to zero or null value
- Measuring cycle data block corrupted or improperly initialized
- Tool offset or workpiece offset rapid traverse settings not configured
- GUD6 parameter file not loaded or synchronized with active channel
- Incomplete measuring cycle definition missing speed correction factor
Troubleshooting Steps
- 1Navigate to Machine > Parameters > GUD6 and verify _SPEED[0] contains a valid non-zero value representing the rapid traverse speed correction factor
- 2Check the measuring cycle block syntax in the part program; ensure all required parameters are defined before cycle execution
- 3Reload GUD6 parameter file using NC > Parameter > Load or reinitialize the channel to restore default values
- 4Verify machine tool rapid traverse speed settings match the correction factor value; adjust _SPEED[0] to appropriate percentage (typically 100%)
- 5Clear the alarm and re-execute the measuring cycle after parameter correction to confirm resolution
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.