61319

Common Causes

• CYCLE114 parameter not properly defined or missing from measurement cycle call
• Incorrect probe offset or probe data not initialized before cycle execution
• Measurement cycle called without required tool offset compensation active
• Conflict between CYCLE114 settings and active workpiece coordinate system
• Corrupted or incomplete cycle library preventing proper parameter validation

Troubleshooting Steps

1. 1Verify CYCLE114 is explicitly called with all required parameters before any dependent measurement cycles (CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994, CYCLE998) are executed
2. 2Check probe calibration data and probe offset values in the measurement setup; re-initialize probe if necessary
3. 3Review the measurement cycle program syntax for correct parameter assignment order and data types matching machine documentation
4. 4Confirm active workpiece coordinate system and tool offset compensation are properly set before cycle execution
5. 5Clear machine memory cache and reload the measurement cycle library from backup or reinstall if corruption is suspected