Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 20-40 minutes

Alarm 61218

Siemens 61218 - Block : Feed/tooth programmed, but number of tools equals zero

For feed per tooth, the number of teeth has to be specified Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Siemens SINUMERIKServo/AxisIntermediate20-40 minutes

61218

Siemens 61218 - Block : Feed/tooth programmed, but number of tools equals zero

Block: Feed/tooth programmed, but number of tools equals zero

For feed per tooth, the number of teeth has to be specified Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • For feed per tooth, the number of teeth has to be specified

Troubleshooting Steps

  1. 1Enter the number of teeth on the milling tool in the "Tool list" menu.
  2. 2Clear alarm with the RESET key. Restart part program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.