axismd.ai
Siemens SINUMERIK Controller
Servo/Axis · Basic · 15-30 minutes
Siemens 61105 - Block : Milling cutter radius too large
The diameter of the cutter used is too large for the form to be machined Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
61105
Siemens 61105 - Block : Milling cutter radius too large
Block: Milling cutter radius too large
The diameter of the cutter used is too large for the form to be machined Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The diameter of the cutter used is too large for the form to be machined
Troubleshooting Steps
- 1Either a tool with a smaller radius has to be used or the contour must be modified.
- 2Clear alarm with the RESET key. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.