Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 300410

Siemens 840D 300410 - Axis drive error when storing a file (,)

This alarm occurs when the CNC system encounters an error while attempting to store measurement data to a file. This is typically a software/programming issue related to file operations, not a mechanical drive fault.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

300410

Siemens 840D 300410 - Axis drive error when storing a file (,)

Axis drive error when storing a file (,)

Siemens SINAMICS drive alarm 300410: Axis drive error when storing a file (,). This alarm indicates a fault condition in the SINAMICS servo drive system. Refer to the Siemens SINAMICS fault list documentation for the complete remedy.

Root Cause Summary

This alarm occurs when the CNC system encounters an error while attempting to store measurement data to a file. This is typically a software/programming issue related to file operations, not a mechanical drive fault.

Safety

  • Refer to Siemens documentation
  • Ensure qualified technician performs repairs

Causes and Fixes

  1. 1

    Check file path and permissions

    Verify the specified file path for storing data is valid and accessible in the CNC control.

  2. 2

    Correct program parameters

    Ensure the program uses correct parameters for file storage operations.

  3. 3

    Test and restart

    Clear the alarm and test the program again after corrections.

Service Recommendedmedium confidence

Call a technician if:

  • ·Always consult qualified CNC programmer or technician for file system modifications
  • ·If alarm persists after basic program verification
  • ·Before making any changes to system file permissions or directories

Prevention

  • Always backup programs before making file operation changes
  • Validate file paths and permissions in offline simulation first
  • Ensure adequate disk space is available before running measurement cycles
  • Follow lockout/tagout procedures when accessing CNC programming functions

Common Mistakes

  • Overlooking file system access restrictions
  • Ignoring specific error code details in the alarm message

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.