axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 17194 - Block no suitable tool found
- An attempt was made to access a tool which has not been defined. - The specified tool does not permit access. - A tool with the desired properties is not available Control reaction: Correction block is reorganized. Interface signals are set. Alarm display. Alarms.
17194
Siemens 17194 - Block no suitable tool found
Block no suitable tool found
- An attempt was made to access a tool which has not been defined. - The specified tool does not permit access. - A tool with the desired properties is not available Control reaction: Correction block is reorganized. Interface signals are set. Alarm display. Alarms.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- - An attempt was made to access a tool which has not been defined.
- - The specified tool does not permit access.
- - A tool with the desired properties is not available
Troubleshooting Steps
- 1Check access to tool: - Are the parameters of the command correctly programmed?
- 2Does the status of the tool prevent access?
- 3Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.