Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Spindle · Intermediate · 30-120 minutes

Alarm 17193

Siemens 17193 - Block the active tool is no longer on toolholder no./spindle no. ,

The tool at the specified toolholder/spindle at which the last tool change was carried out as master toolholder or master spindle, has been replaced. Example: N10 SETHTH(1) N20 T="Wz1"; Tool change at master toolholder 1 N30 SETMTH(2) N40 T1="Wz2"; Toolholder 1 is only a secondary toolholder. Changing the tool does not result in correction deselection. N50 D5; New correction selection. At present, there is no active tool which D can refer to, i.e. D5 refers to T no. = 0, which results in zero correction Control reaction: Interface signals are set. Alarm display.

Siemens SINUMERIKSpindleIntermediate30-120 minutes

17193

Siemens 17193 - Block the active tool is no longer on toolholder no./spindle no. ,

Block the active tool is no longer on toolholder no./spindle no.,

The tool at the specified toolholder/spindle at which the last tool change was carried out as master toolholder or master spindle, has been replaced. Example: N10 SETHTH(1) N20 T="Wz1"; Tool change at master toolholder 1 N30 SETMTH(2) N40 T1="Wz2"; Toolholder 1 is only a secondary toolholder. Changing the tool does not result in correction deselection. N50 D5; New correction selection. At present, there is no active tool which D can refer to, i.e. D5 refers to T no. = 0, which results in zero correction Control reaction: Interface signals are set. Alarm display.

Safety

  • Spindle hazard: ensure the spindle is at standstill before working near it; follow lockout/tagout procedures.

Common Causes

  • The tool at the specified toolholder/spindle at which the last tool change was carried out as master toolholder or master spindle, has been replaced.
  • Example: N10 SETHTH(1) N20 T="Wz1" ; Tool change at master toolholder 1 N30 SETMTH(2) N40 T1="Wz2" ; Toolholder 1 is only a secondary toolholder.
  • Changing the tool does not result in correction deselection.

Troubleshooting Steps

  1. 1Modify program: - Set desired spindle as master spindle or toolholder as master toolholder.
  2. 2Then, if required, reset master spindle or master toolholder.
  3. 3Clear alarm with the Delete key or NC START

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.