axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 20-40 minutes
Siemens 14755 - Channel block motion synchronous actions without traverse
The programmed motion synchronous action and the function "Several feeds" require a traversing motion or the value of the traversing motion is 0. This alarm is no longer used after P3.2 Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
14755
Siemens 14755 - Channel block motion synchronous actions without traverse
Channel block motion synchronous actions without traverse
The programmed motion synchronous action and the function "Several feeds" require a traversing motion or the value of the traversing motion is 0. This alarm is no longer used after P3.2 Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The programmed motion synchronous action and the function "Several feeds" require a traversing motion or the value of the traversing motion is 0.
- This alarm is no longer used after P3.2
Troubleshooting Steps
- 1Modify part program.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.