Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 14761

Siemens 14761 - Block motion synchronous action: DELDTG function not allowed

Rapid delete distance-to-go for synchronous actions is not allowed with DELDTG when tool radius compensation is active Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

14761

Siemens 14761 - Block motion synchronous action: DELDTG function not allowed

Block motion synchronous action: DELDTG function not allowed

Rapid delete distance-to-go for synchronous actions is not allowed with DELDTG when tool radius compensation is active Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • Rapid delete distance-to-go for synchronous actions is not allowed with DELDTG when tool radius compensation is active

Troubleshooting Steps

  1. 1Deactivate tool radius compensation before performing rapid delete distance-to-go and then reselect or as of SW 4.3: "Delete distance-to-go without preparation".
  2. 2Clear alarm with NC START or RESET key and continue the program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.