Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 14754

Siemens 14754 - Block motion synchronous action: wrong feed type

The active feed type is not allowed for the motion synchronous action or for the function "Several feeds" Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

14754

Siemens 14754 - Block motion synchronous action: wrong feed type

Block motion synchronous action: wrong feed type

The active feed type is not allowed for the motion synchronous action or for the function "Several feeds" Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The active feed type is not allowed for the motion synchronous action or for the function "Several feeds"

Troubleshooting Steps

  1. 1Modify part program.
  2. 2Clear alarm with NC START or RESET key and continue the program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.