axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 14412 - Block transformation active at geometry axis changeover
It is not permissible to change the assignment of geometry axes to channel axes when transformation is active Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
14412
Siemens 14412 - Block transformation active at geometry axis changeover
Block transformation active at geometry axis changeover
It is not permissible to change the assignment of geometry axes to channel axes when transformation is active Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- It is not permissible to change the assignment of geometry axes to channel axes when transformation is active
Troubleshooting Steps
- 1Modify part program.
- 2Alarms NCK alarms
- 3Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.