axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 14432 - Block Rounding length for tangential axis is too small.
For a tangential axis that is coupled during preparation, a rounding length must be indicated with TANGON on activating the tangential control, or possibly occuring discontinuities of the tangential axis cannot be smoothed. This rounding length must be larger than 1 increment Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
14432
Siemens 14432 - Block Rounding length for tangential axis is too small.
Block Rounding length for tangential axis is too small.
For a tangential axis that is coupled during preparation, a rounding length must be indicated with TANGON on activating the tangential control, or possibly occuring discontinuities of the tangential axis cannot be smoothed. This rounding length must be larger than 1 increment Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- For a tangential axis that is coupled during preparation, a rounding length must be indicated with TANGON() on activating the tangential control, or possibly occuring discontinuities of the tangential axis cannot be smoothed.
- This rounding length must be larger than 1 increment
Troubleshooting Steps
- 1Modify part program
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.