axismd.ai
Siemens SINUMERIK Controller
Servo/Axis · Intermediate · 30-60 minutes
Siemens 14541 - Block contour tool: the max. limit angle has been programmed more
The limit angle of a contour tool must be equal zero in an involved edge only Control reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end.
14541
Siemens 14541 - Block contour tool: the max. limit angle has been programmed more
Block contour tool: the max. limit angle has been programmed more
The limit angle of a contour tool must be equal zero in an involved edge only Control reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- The limit angle of a contour tool must be equal zero in an involved edge only
Troubleshooting Steps
- 1Change tool definition.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.