axismd.ai
Siemens SINUMERIK Controller
Program/G-code · Intermediate · 30-120 minutes
Siemens 14415 - Block tangent control: changeover geometry/channel axis not
An assignment change of the geometry axes to channel axes is not permitted with active tangential control Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
14415
Siemens 14415 - Block tangent control: changeover geometry/channel axis not
Block tangent control: changeover geometry/channel axis not
An assignment change of the geometry axes to channel axes is not permitted with active tangential control Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.
Safety
- Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.
Common Causes
- An assignment change of the geometry axes to channel axes is not permitted with active tangential control
Troubleshooting Steps
- 1Change part program and delete active tangential control with TANGDEL.
- 2Clear alarm with NC START or RESET key and continue the program. Continuation: Alarms
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.