Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 60-120 minutes

Alarm 14401

Siemens 14401 - Block transformation not available

The required transformation is not available Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. Alarms.

Siemens SINUMERIKProgram/G-codeIntermediate60-120 minutes

14401

Siemens 14401 - Block transformation not available

Block transformation not available

The required transformation is not available Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. Alarms.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The required transformation is not available

Troubleshooting Steps

  1. 1Please inform the authorized personnel/service department.
  2. 2Modify part program; program defined transformations only.
  3. 3Check MD 24... $MC_TRAFO_TYPE_... (assigns the transformation to part program instruction).
  4. 4Clear alarm with the RESET key. Restart part program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.