Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 14092

Siemens 14092 - Block axis is wrong axis type

One of the following programming errors has occurred: 1. The keyword WAITP(x) "Wait with block change until the specified positioning axis has reached its end point" has been used for an axis that is not a positioning axis. 2. G74 "Reference point approach from the program" has been programmed for a spindle. (Only axis addresses are permitted). 3. The keyword POS/POSA has been used for a spindle. (The keywords SPOS and SPOSA must be programmed for spindle positioning). 4. If the alarm occurs with the "Rigid tapping" function (G331), the following causes are conceivable: - The master spindle is not in position-controlled mode. - Incorrect master spindle - Master spindle without encoder 5. An axis name was programmed which no longer exists (e.g. when using axial variables as an index). Or NO_AXIS has been programmed as an index. 6. If 14092 is output as a note with alarm 20140 Motion-synchronous action: traversing of command axis, the following causes are possible: - The axis is currently being traversed by the NC program already. - An overlaid movement is active for the axis. - The axis is active as following axis of a coupling. - An interpolation compensation such as a temperature compensation is active for the axis Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

14092

Siemens 14092 - Block axis is wrong axis type

Block axis is wrong axis type

One of the following programming errors has occurred: 1. The keyword WAITP(x) "Wait with block change until the specified positioning axis has reached its end point" has been used for an axis that is not a positioning axis. 2. G74 "Reference point approach from the program" has been programmed for a spindle. (Only axis addresses are permitted). 3. The keyword POS/POSA has been used for a spindle. (The keywords SPOS and SPOSA must be programmed for spindle positioning). 4. If the alarm occurs with the "Rigid tapping" function (G331), the following causes are conceivable: - The master spindle is not in position-controlled mode. - Incorrect master spindle - Master spindle without encoder 5. An axis name was programmed which no longer exists (e.g. when using axial variables as an index). Or NO_AXIS has been programmed as an index. 6. If 14092 is output as a note with alarm 20140 Motion-synchronous action: traversing of command axis, the following causes are possible: - The axis is currently being traversed by the NC program already. - An overlaid movement is active for the axis. - The axis is active as following axis of a coupling. - An interpolation compensation such as a temperature compensation is active for the axis Control reaction: Correction block is reorganized. Interface signals are set. Alarm display.

Safety

  • Spindle hazard: ensure the spindle is at standstill before working near it; follow lockout/tagout procedures.

Common Causes

  • One of the following programming errors has occurred: 1.
  • The keyword WAITP(x) "Wait with block change until the specified positioning axis has reached its end point" has been used for an axis that is not a positioning axis.
  • 2.

Troubleshooting Steps

  1. 1Correct the part program according to which of the above errors is involved.
  2. 2
  3. 3Clear alarm with NC START or RESET key and continue the program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.