What causes Siemens SINUMERIK alarm 108008?

Part program contains an illegal or unsupported command for the current machine configuration. Parameter or machine data setting incompatible with the commanded operation. Required option or function not enabled on this SINUMERIK control. Incorrect axis assignment or configuration for the commanded function. Software version or compile cycle version mismatch.

How do I fix Siemens SINUMERIK alarm 108008?

1. Note the full alarm message including any parameter values shown (e.g., axis number, block number, channel). 2. Identify the program block or operation that triggered the alarm. 3. Review the SINUMERIK alarm manual for alarm 108008 to identify the specific cause and remedy. 4. Check the relevant machine data parameters referenced in the alarm. 5. If the alarm persists after correcting the program, contact Siemens technical support with the full alarm text and machine data backup.

Siemens SINUMERIK codes

axismd.ai

Siemens SINUMERIK Controller

Program/G-code · Intermediate · 30-120 minutes

Alarm 108008

Siemens 840D 108008 - Not possible to proceed to previous transition

Siemens SINUMERIK alarm 108008: Not possible to proceed to previous transition. This alarm indicates an error condition in the NC program or control configuration that must be resolved before the operation can continue.

Siemens SINUMERIKProgram/G-codeIntermediate30-120 minutes

108008

Siemens 840D 108008 - Not possible to proceed to previous transition

Not possible to proceed to previous transition

Safety

Refer to Siemens documentation
Ensure qualified technician performs repairs

Common Causes

Part program contains an illegal or unsupported command for the current machine configuration
Parameter or machine data setting incompatible with the commanded operation
Required option or function not enabled on this SINUMERIK control
Incorrect axis assignment or configuration for the commanded function
Software version or compile cycle version mismatch

Troubleshooting Steps

1Note the full alarm message including any parameter values shown (e.g., axis number, block number, channel).
2Identify the program block or operation that triggered the alarm.
3Review the SINUMERIK alarm manual for alarm 108008 to identify the specific cause and remedy.
4Check the relevant machine data parameters referenced in the alarm.
5If the alarm persists after correcting the program, contact Siemens technical support with the full alarm text and machine data backup.

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.