axismd.ai
Siemens SINUMERIK Controller
Servo/Axis · Intermediate · 30-120 minutes
Siemens 10741 - Block direction reversal with WAB infeed motion
A safety distance which has been programmed is located perpendicular to the machining plane and not between the start and end point of the WAB contour Control reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end.
10741
Siemens 10741 - Block direction reversal with WAB infeed motion
Block direction reversal with WAB infeed motion
A safety distance which has been programmed is located perpendicular to the machining plane and not between the start and end point of the WAB contour Control reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end.
Safety
- Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.
Common Causes
- A safety distance which has been programmed is located perpendicular to the machining plane and not between the start and end point of the WAB contour
Troubleshooting Steps
- 1Modify part program.
- 2Clear alarm with NC START or RESET key and continue the program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.