600-0302

Access Tool Table

Press MOD key, select 'Tables' and open TOOL.T table to verify tool entries for the slide number referenced in alarm.

Use filter function in tool table to display only tools assigned to specific slide numbers

Verify Slide Assignment Column

Check column 'KINEMATIC' or 'SLIDE' in tool table and ensure tools have proper slide number assignments matching your machine configuration.

Incorrect slide assignments can cause collision during tool changes

Add Missing Tool Entries

Create new tool entries with correct slide number assignment, tool length, and radius compensation values for the referenced slide.

Copy existing tool entries and modify slide assignment to maintain consistent tool data structure

Save and Reset Control

Save tool table changes and perform control reset (END + 1) to reload tool management data into active memory.

Access Machine Parameters

Enter MOD mode, select 'Machine Parameters' and navigate to MP7440 series for turret configuration parameters.

Machine parameter changes require proper authorization level and may affect machine safety

Verify Turret Configuration MPs

Check MP7440.x (number of turret positions), MP7441.x (turret type), and MP7442.x (slide assignment) for the slide number in question.

Document original parameter values before making changes for easy rollback if needed

Configure Slide Geometry Parameters

Set MP7500.x through MP7519.x to define slide geometry, tool change positions, and kinematic relationships for the referenced slide.

Use machine manufacturer's parameter documentation for exact values specific to your machine model

Activate Parameter Changes

Save parameters and perform complete control restart to activate new turret and slide configuration settings.

Identify Program Line with Error

Review the NC program line where alarm occurred, typically containing T-word tool call or explicit slide selection command.

Use TNC's program search function (GOTO) to quickly locate the problematic line number

Verify Slide Number Range

Check machine parameter MP7430 (number of slides) to confirm valid slide number range, typically 0 to configured maximum.

Slide numbering may start from 0 or 1 depending on machine manufacturer configuration

Correct Program Slide Reference

Modify the T-word or slide selection command to reference a valid, configured slide number within the machine's defined range.

Use consistent slide numbering convention throughout the program to avoid confusion

Validate Program Syntax

Run program syntax check (Test Run mode) to verify corrected slide references don't generate additional alarms.

Access Turret Table

Navigate to MOD > Tables > TUR.T to examine turret configuration table for data corruption or missing entries.

Look for unusual characters, blank entries, or inconsistent data formatting in the table

Backup and Restore Turret Data

Create backup of current turret table, then restore from known good backup or recreate turret configuration from machine documentation.

Always backup current configuration before restoring to prevent complete data loss

Verify File System Integrity

Check TNC file system for errors using built-in diagnostic tools and repair any detected file system corruption.

Perform regular file system maintenance during scheduled downtime to prevent corruption issues

Reinitialize Turret System

Perform turret system reinitialization through service menu to rebuild internal data structures from corrected table data.