What causes Haas alarm 213?

MOCON board RAM chip hardware failure or degradation causing intermittent read or write errors in program storage area. Electrostatic discharge event or voltage spike damaging memory circuits and corrupting stored program data. Low or fluctuating DC voltage supply to MOCON board from PSUP causing unstable memory operations and data corruption. Loose or oxidized ribbon cable connections between MOCON and memory modules creating intermittent communication errors. Extended machine age with original MOCON board experiencing memory chip wear and reduced data retention capability.

How do I fix Haas alarm 213?

1. Step 1: Power down machine completely for 30 seconds then restart to allow control to reinitialize memory and recalculate CRC values 2. Step 2: Access control Diagnostics page and check MOCON board status for any memory test failures or hardware error flags 3. Step 3: Measure DC voltages at PSUP board outputs and verify stable 5V, 12V, and 24V supplies within specification tolerances 4. Step 4: Reseat all ribbon cables and connectors on MOCON board to eliminate oxidation or intermittent connection issues 5. Step 5: Delete all programs from memory, perform a parameter reset to defaults, and reload programs to clear software corruption 6. Step 6: If CRC error persists after memory clear and stable power confirmed, replace MOCON board as RAM hardware has failed

Haas codes

axismd.ai

Haas Controller

Program/G-code · Intermediate · 45-60 minutes

Alarm 213

Haas 213 - PROGRAM RAM CRC ERROR | Haas CNC Alarm

This alarm is triggered when the MOCON board detects a cyclic redundancy check error in the program RAM area during startup self-test or periodic memory verification. The control performs CRC calculations on stored program memory to ensure data integrity, and a mismatch indicates memory corruption or hardware failure. The machine will not allow program execution until the memory integrity is restored.

HaasProgram/G-codeIntermediate45-60 minutes

213

Haas 213 - PROGRAM RAM CRC ERROR | Haas CNC Alarm

PROGRAM RAM CRC ERROR

Common Causes

MOCON board RAM chip hardware failure or degradation causing intermittent read or write errors in program storage area
Electrostatic discharge event or voltage spike damaging memory circuits and corrupting stored program data
Low or fluctuating DC voltage supply to MOCON board from PSUP causing unstable memory operations and data corruption
Loose or oxidized ribbon cable connections between MOCON and memory modules creating intermittent communication errors
Extended machine age with original MOCON board experiencing memory chip wear and reduced data retention capability

Troubleshooting Steps

1Step 1: Power down machine completely for 30 seconds then restart to allow control to reinitialize memory and recalculate CRC values
2Step 2: Access control Diagnostics page and check MOCON board status for any memory test failures or hardware error flags
3Step 3: Measure DC voltages at PSUP board outputs and verify stable 5V, 12V, and 24V supplies within specification tolerances
4Step 4: Reseat all ribbon cables and connectors on MOCON board to eliminate oxidation or intermittent connection issues
5Step 5: Delete all programs from memory, perform a parameter reset to defaults, and reload programs to clear software corruption
6Step 6: If CRC error persists after memory clear and stable power confirmed, replace MOCON board as RAM hardware has failed

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.