Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Communication · Intermediate · 20-40 minutes

Alarm 8032

Siemens 8032 - Option 'activation of more than link axes' not set

The option for the number of link axes does not match the number of axes programmed in MD10002 $MN_AXCONF_LOGIC_MACHAX_TAB Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Siemens SINUMERIKCommunicationIntermediate20-40 minutes

8032

Siemens 8032 - Option 'activation of more than link axes' not set

Option 'activation of more than link axes' not set

The option for the number of link axes does not match the number of axes programmed in MD10002 $MN_AXCONF_LOGIC_MACHAX_TAB Control reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display.

Safety

  • Only qualified personnel should diagnose and clear control alarms; follow the machine builder's safety procedures and lockout/tagout where hardware work is required.

Common Causes

  • The option for the number of link axes does not match the number of axes programmed in MD10002 $MN_AXCONF_LOGIC_MACHAX_TAB

Troubleshooting Steps

  1. 1Buy option - Configure fewer link axes
  2. 2Clear alarm with the RESET key. Restart part program

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.