axismd.ai
Siemens SINUMERIK Controller
Communication · Intermediate · 30-120 minutes
Siemens 380070 - PROFIBUS/PROFINET: No input slot available for basic address (length )
This alarm occurs when the Profibus DP configuration lacks available input slots at the specified base address, often due to slot allocation conflicts, incorrect addressing, or hardware configuration mismatches. Always follow lockout/tagout procedures before making any configuration changes.
380070
Siemens 380070 - PROFIBUS/PROFINET: No input slot available for basic address (length )
PROFIBUS/PROFINET: No input slot available for basic address (length)
An incorrect logical base address was specified for a digital or analog input. Either no slot has been configured for this base address or the requested area extends beyond the end of the slot. Length=1 indicates a digital input. Length=2 indicates a analog input Control reaction: Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. Alarms Drive and I/O alarms.
Root Cause Summary
This alarm occurs when the Profibus DP configuration lacks available input slots at the specified base address, often due to slot allocation conflicts, incorrect addressing, or hardware configuration mismatches. Always follow lockout/tagout procedures before making any configuration changes.
Safety
- Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.
Causes and Fixes
- 1
SAFETY: Apply lockout/tagout procedures
Ensure machine is in safe state and properly locked out before accessing configuration settings.
- 2
Document current state
Record current alarm details including base address (%1) and length (%2) values before making changes.
- 3
Review Profibus DP configuration
Check HW Config or equivalent for slot assignments, address ranges, and potential conflicts with existing modules.
- 4
Correct configuration and verify
Adjust base addresses to avoid conflicts, download configuration, and test in safe mode before normal operation.
Call a technician if:
- ·If unfamiliar with Profibus DP configuration procedures
- ·If hardware replacement or network reconfiguration is required
- ·If alarm persists after configuration verification
- ·If unsure about safe lockout procedures for the specific machine
Prevention
- Validate input addresses against Profibus DP configuration before running
- Use simulation to catch configuration mismatches
Common Mistakes
- Overlooking the base address value in the alarm
- Assuming hardware fault instead of configuration error
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.