Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Communication · Intermediate · 30-120 minutes

Alarm 380072

Siemens 380072 - PROFIBUS/PROFINET: Output slot for basic address (size ) not allowed

An incorrect logical base address was set for a digital or analog output, the area is resides in the access range of the PLC (PIQ, base addresses < 256). For length =1 it is a digital output, For length =2 it is an analog output Control reaction: Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display.

Siemens SINUMERIKCommunicationIntermediate30-120 minutes

380072

Siemens 380072 - PROFIBUS/PROFINET: Output slot for basic address (size ) not allowed

PROFIBUS/PROFINET: Output slot for basic address (size) not allowed

An incorrect logical base address was set for a digital or analog output, the area is resides in the access range of the PLC (PIQ, base addresses < 256). For length =1 it is a digital output, For length =2 it is an analog output Control reaction: Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display.

Safety

  • Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.

Common Causes

  • An incorrect logical base address was set for a digital or analog output, the area is resides in the access range of the PLC (PIQ, base addresses < 256).
  • For length =1 it is a digital output, For length =2 it is an analog output

Troubleshooting Steps

  1. 1Only use addresses outside the PLC process image (e.g. >= 256) for output slots.
  2. 2Enter correct basic addresses in the machine data: - For length=1: Correct machine data MN_HW_ASSIGN_DIG_FASTOUT.
  3. 3For length=2: Correct machine data MN_HW_ASSIGN_ANA_FASTOUT.
  4. 4NCK restart If the error cannot be eliminated by this procedure, please make a note of the error text and contact the control system manufacturer.
  5. 5Switch control OFF - ON. Continuation: Alarms Drive and I/O alarms

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.