axismd.ai
Siemens SINUMERIK Controller
Servo/Axis · Intermediate · 30-120 minutes
Siemens 310763 - Axis drive D component of force controller invalid
The D component of the force controller MD 5246: FORCECTRL_DIFF_TIME is too high Control reaction: NC not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Channel not ready.
310763
Siemens 310763 - Axis drive D component of force controller invalid
Axis drive D component of force controller invalid
The D component of the force controller MD 5246: FORCECTRL_DIFF_TIME is too high Control reaction: NC not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Channel not ready.
Safety
- Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.
Common Causes
- The D component of the force controller MD 5246: FORCECTRL_DIFF_TIME is too high
Troubleshooting Steps
- 1Enter a smaller value for the D component of the force controller MD 5246: FORCECTRL_DIFF_TIME.
- 2Clear alarm with the RESET key in all channels. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.