axismd.ai
Siemens SINUMERIK Controller
Servo/Axis · Intermediate · 30-120 minutes
Siemens 310771 - Axis drive gain in fine area of valve characteristic is less than or
The gradient in the fine area of the valve characteristic is less than or equal to zero Control reaction: NC not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Channel not ready.
310771
Siemens 310771 - Axis drive gain in fine area of valve characteristic is less than or
Axis drive gain in fine area of valve characteristic is less than or
The gradient in the fine area of the valve characteristic is less than or equal to zero Control reaction: NC not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Channel not ready.
Safety
- Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.
Common Causes
- The gradient in the fine area of the valve characteristic is less than or equal to zero
Troubleshooting Steps
- 1The gradient in the fine area is calculated as follows: - Positive quadrant: (MD 5464 - MD 5480) / (MD 5465 -5481) - Negative quadrant: (MD 5467 - MD 5483) / (MD 5468 - 5484) Enter a valid combination in the above drive MD.
- 2Clear alarm with the RESET key in all channels. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.