axismd.ai
Siemens SINUMERIK Controller
Servo/Axis · Intermediate · 30-120 minutes
Siemens 310612 - Axis drive force limitation off
The force limitation is deactivated. Cause: The force limitation is deactivated but: - The NC has defined a force limit or - Travel to fixed stop is selected Control reaction: Mode group not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Channel not ready.
310612
Siemens 310612 - Axis drive force limitation off
Axis drive force limitation off
The force limitation is deactivated. Cause: The force limitation is deactivated but: - The NC has defined a force limit or - Travel to fixed stop is selected Control reaction: Mode group not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Channel not ready.
Safety
- Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.
Common Causes
- The force limitation is deactivated.
- Cause: The force limitation is deactivated but: - The NC has defined a force limit or - Travel to fixed stop is selected
Troubleshooting Steps
- 1Activate power limitation: Modify MD 5241: Set bit 0.
- 2Clear alarm with the RESET key in all channels of this mode group. Restart part program
Seeing Multiple Alarms?
Seeing another alarm with this one? Enter the code.
Get machine-aware diagnosis
AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.
Start freeWas this guide helpful?
Always verify with your machine manual or a certified technician before performing service procedures.