Siemens SINUMERIK codes
AxisMD

axismd.ai

Siemens SINUMERIK Controller

Servo/Axis · Intermediate · 30-120 minutes

Alarm 300012

Siemens 300012 - Axis drive hardware version of control module not supported

There is a drive module with an "old" control module on the drive bus. 810D does not support these modules. Ramp-up is interrupted Control reaction: NC not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm.

Siemens SINUMERIKServo/AxisIntermediate30-120 minutes

300012

Siemens 300012 - Axis drive hardware version of control module not supported

Axis drive hardware version of control module not supported

There is a drive module with an "old" control module on the drive bus. 810D does not support these modules. Ramp-up is interrupted Control reaction: NC not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm.

Safety

  • Drive/power/encoder circuit: hazardous voltages may remain in the DC link after power-off. Lock out / tag out, wait for discharge per the drive documentation, and use qualified personnel only.

Common Causes

  • There is a drive module with an "old" control module on the drive bus.
  • 810D does not support these modules.
  • Ramp-up is interrupted

Troubleshooting Steps

  1. 1Please inform the authorized personnel/service department.
  2. 2Order standard or performance control module and exchange with "old".
  3. 3Switch control OFF - ON

Seeing Multiple Alarms?

Seeing another alarm with this one? Enter the code.

Get machine-aware diagnosis

AxisMD logs alarms against your actual machines, tracks patterns, and gives AI context your manual doesn't have.

Start free

Was this guide helpful?

Always verify with your machine manual or a certified technician before performing service procedures.